Effects of Cutting Planes on Filter Performance of FDM 3D-Printed X-Band Waveguide Filters

In this paper, the impact of E-plane and H-plane cuts on filter performance of 3D-printed waveguide filters manufactured with fused deposition modeling (FDM) is examined. The employed manufacturing procedure consists of FDM 3D-printing and the subsequent electroplating process. A number of samples in both configurations are fabricated and surveyed. The measurement results are quantified and a comparison is conducted. Finally, the differing filter behaviors are discussed.

Rechte

Nutzung und Vervielfältigung:

Keine Lizenz. Es gelten die Bestimmungen des deutschen Urheberrechts (UrhG).

Bitte beachten Sie, dass einzelne Bestandteile der Publikation anderweitigen Lizenz- bzw. urheberrechtlichen Bedingungen unterliegen können.

Zitieren

Zitierform:
Bruhn, D., Miek, D., Braasch, K.N., Kamrath, F.L., Bartlett, C.D., Boe, P., Höft, M., 2021. Effects of Cutting Planes on Filter Performance of FDM 3D-Printed X-Band Waveguide Filters, in: 2021 IEEE MTT-S International Microwave Filter Workshop (IMFW). IEEE, Perugia, Italy. https://doi.org/10.1109/IMFW49589.2021.9642301
Zitierform konnte nicht geladen werden.